My new V15 pulses and displays false “airways blocked” message only when using the laser head on bare floors on auto power setting. It works fine on auto with all other attachments. I live at 9150 ft. above sea level. The machine was sent to Denver (5280 ft.) for repair, and they could not duplicate the issue. If I reduce suction power to eco, it works fine. In looking at the airway of the laser head, the diameter of the inlet is smaller than the other heads and attachments. Could this be an air pressure sensing issue? Anyone else at altitude with this problem?
Create a Community account to start contributing.
New here? Register below. To activate you account and be able to post on the community, don't forget to click on the link in your activation email.
Login to the community
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.