I need to know how to add a new zone to the existing map of a Dyson 360 Vis Nav? If that is an option.
There were a room that was not available when the machine was mapping, later when that the room was available the robot did clean it but it was not added to the map. I could see the room in the activity but not in the map. I have check every possible avenue to non available. The only option I could see will be to create a new map. Is that the only option?
Hi
Welcome to the Dyson Community!
As you’ve mentioned, you’ll need to allow your Dyson 360 Vis Nav
robot to complete another mapping session to achieve this. Make sure all the areas you want represented on your map are accessible to your robot during it’s mapping session. Once this is complete, you can then divide the map into zones as needed.
Hope this helps, but let us know if you have any other questions!
New here? Register below. To activate you account and be able to post on the community, don't forget to click on the link in your activation email.
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.