Visit Dyson.com Visit Dyson.com

Community
Dyson cordless vacuums and wet cleaners
Maintaining your Dyson cordless vacuum

Maintaining your Dyson cordless vacuum

Keep your Dyson cordless vacuum performing at its best. Post questions about machine maintenance here.

188 Posts
578 Replies

When you subscribe we will email you when there is a new topic in this category

188 Posts

Recently active

Most replies Most views Newest first

DavidTaylorCommunity Superuser

published in Maintaining your Dyson cordless vacuum

Understanding Battery DegradationSPOTLIGHTED POST

Since the community became inclusive of all Dyson technology, of late, I’ve responded to discussions surrounding the Cordless vacuums and their battery life expectancy. Specifically, on the belief these should last for a substantial time past their warranty expiration.Having a working knowledge of battery development, I wanted to share my own opinion on this subject.Battery failure is sadly unpredictable. It exclusively can’t be tracked to a singular cause, and it is important to note that this doesn’t just affect vacuum batteries but any rechargeable battery in modern society. The battery in power tools, remote control cars through to that of the rechargeable AA/AAA batteries in use around the home, all fall foul of degradation over time.A combination of sources can influence the capacity, discharge, and operation of these batteries. These sources are inclusive of, overcharging, undercharging, discharging, local temperature, local humidity, component maintenance, and prolonged impact

34621

1 year ago

denisedalemNew Member

asked in Maintaining your Dyson cordless vacuum

dyson outsize

I have the Dyson Outsize. When I was emptying the bin, the red rubber ring and a grey plastic ring fell loose. I can not figure out where it goes on the bin. Inside or out? I can’t find any close of pictures of the bin to see. Should I call Dyson? Or does anyone have any advice for me. ?

8 days ago

spotlucyNew Member

asked in Maintaining your Dyson cordless vacuum

putting cordless vacuum in storage

We are putting our 12 month old gens5 complete detect cordless vacuum into storage for six months, what should I do with the battery, do I leave it fully charged?

29 days ago

NanaNew Member

asked in Maintaining your Dyson cordless vacuum

urgently need V8 vacuum parts

Hi there, the Dyson V8 stick vacuum is not a 'retired' model. They are still being sold in full. However parts have not been available for months (in Australia). I need to replace the V8 motor head asap (it has started scratching our floors) and also need the V8 replacement battery. I have checked the Spares2go 'genuine parts' store on Amazon. It gets really bad reviews. Where can I get official replacement parts for Australia ASAP? If the vacuums are still being sold, why can't we order the parts from Dyson store?

1 month ago

PhiltheFishNew Member

asked in Maintaining your Dyson cordless vacuum

Using Dyson cordless vacuum in summer house

Hi. I have a summer house which I use for 3 months a year. I have a Dyson cordless vacuum at home and I would like to get another for my summer house but I’m worried that it won’t like sitting there without charge for several months (we turn off the power when we leave the house). Does anyone know whether the vacuum’s performance will be impaired by leaving it uncharged for several months? Thanks

1 month ago

adeeNew Member

asked in Maintaining your Dyson cordless vacuum

V15 Detect Brush head coming apart from first use, what do i do?

I literally just bought this, after using this within 24 hours it is coming apart, the red strip on the brush head is coming off already… Anyone else experience this, Is this a defected part or just quality of these things are not up to par, what can I do?

2 months ago

adammaroNovice Member

asked in Maintaining your Dyson cordless vacuum

HoneybeeNew Member

asked in Maintaining your Dyson cordless vacuum

Losing power - blue light solid on charging

My dyson V7 seems to be losing power very quickly, it appears to be charging as the blue light is solid when on charge, no flashing etc as others have. It works but then cuts out after 5 mins or so, is this just the battery not holding charge? We have not replaced the battery and had the dyson a number of years.?

2 months ago

tugcekocaNew Member

asked in Maintaining your Dyson cordless vacuum

Dyson V8 Absolute Power issue with poor Customer Service

Hello, I am writing to express my extreme disappointment and frustration with the recent experience I had with Dyson's customer service regarding my Dyson V8 Absolute vacuum cleaner.Approximately three years ago, I made the decision to invest in a Dyson V8 Absolute in Portugal, believing in the quality and reliability of Dyson products. However, my confidence in the brand has been severely shaken due to the issues I encountered with my vacuum cleaner.Recently, my Dyson V8 Absolute stopped charging, leaving me unable to use it effectively. Naturally, I reached out to Dyson's customer service department seeking assistance. However, the response I received was far from satisfactory. Initially, I was advised to purchase a new battery, which I found perplexing considering the age of the vacuum cleaner. When I questioned the rationale behind this suggestion, I was then instructed to purchase a new cable.This back-and-forth exchange left me feeling frustrated and disillusioned. It became appa

2 months ago

jack.bNew Member

asked in Maintaining your Dyson cordless vacuum

V15 main body coming apart when emptying

When I empty the main compartment of my V15 detect plus the entire cartridge comes apart from the machine. On the app there is a video on how to replace the main body, but I cannot emptying the vacuum without it disassembling itself which is very messy. How can this be fixed? It seems like whatever part is supposed to stop it coming off unless the red button with the 1 on it is pressed isn’t working.

3 months ago

wj3b47New Member

asked in Maintaining your Dyson cordless vacuum

v8 (?) four flashing red lights, then one flashing blue one

Context:The vacuum I’m using is not sucking.I’m half sure it’s a v8 Animal.Pushing its trigger shows 4 flashing red, then 1 blue light. I learnt 4 flashing red lights indicate that it’s a battery issue, but the blue light threw me off. Being a US model, the first three characters of the vacuum’s serial number won’t show up in the Singaporean Dyson website.I see that there are Batteries D and E for this vacuum and that the E one is suitable.Questions:Is it a v8 Animal? Is it a battery issue, or something else? If it is a battery issue, is the Dyson V8 Battery E compatible with this Dyson vacuum? Otherwise, how do I resolve the vacuum not sucking?

3 months ago

ittaitalNew Member

asked in Maintaining your Dyson cordless vacuum

Cordless V11 floor head doesn't spin

New v11 machine, less than 1 year old. The floor head of this model uses a spinning head (roller) which stopped spinning. The device is very clean and well kept, no hair or debris, etc. Is clogging the rollers way. I had cleaned and maintained it. To me it seems that the roller head doesn't get any DC power via its electrical contact points. My biggest problem is that the local distributor tells me that there is no warranty for the roller head. This is an unaccepted answer. First thing, the roller head is a crucial part of the machine. Secondly, the problem arises from the main unit, not the roller head. What can I do to get this machine back in order? (Edited by moderator – Tags amended)

3 months ago

AstroNew Member

asked in Maintaining your Dyson cordless vacuum

Fluffy Optic Issues and Availability

Haven’t had my V12 Detect Slim for long but recently went to clean the Fluffy Optic head because hair was getting tangled around the wheels etc. After removing the brush bar I found that there was hair caught around the locking cap so pulled it apart to clear it. It became apparent that hair seemed to have melted/fused into something plastic around the axle. I contacted Dyson and they viewed the issue through my phone and because they didn’t have a part available she suggested that I return the whole machine to them or take it to my local repairer. Bit reluctant to return the whole thing when there is only one part required. I checked with my local repairer and he said that if Dyson didn’t have the part then neither would he so it was pointless to take it to him. I am just wondering if the brush bar for the LED Slim Fluffy is the same as the one in my Fluffy Optic? Also wondering what they would do if I did send the whole thing back to them, how long would I be without a vacuum

3 months ago

LourdaNovice Member

asked in Maintaining your Dyson cordless vacuum

Dyson Cordless V15 clean filter message - Suggestions?

I have my V15 about a month. I used it on some really dirty mats one day and decided to clean the filter.now every time I use it the clean filter message comes up.I don’t know what to do. I’m really worried that the filter wasn’t completely dry when I put it back on. (Moderation Edit - Converted to Question)

3 months ago

erellauraNew Member

asked in Maintaining your Dyson cordless vacuum

Mattress tool for V8 cleaning tips

What’s the best way to clean the mattress tool attachment for V8?

3 months ago

rp37New Member

asked in Maintaining your Dyson cordless vacuum

My Dyson V10 is pulsing and has a blockage light despite fully cleaning and replacing filter!

I’ve fully cleaned my vacuum, removed all dust that may be causing a blockage and even replaced the filter but I’m still getting a blockage light warning and the pulsing. I can’t figure out what could be the issue and haven’t found any other topics on here that mention the exact same thing?!

3 months ago

MitruhlarNew Member

asked in Maintaining your Dyson cordless vacuum

v12 detech needs filter cleaned after every use?

I am prompted by my v12 detect to clean the filter after every use. According to Dyson this warning should only appear about once per month. Does anyone know why this happens? Is it a defective part?

3 months ago

AlbaloneRookie Member

asked in Maintaining your Dyson cordless vacuum

vacuum not working when plugged in accessories

Hi I have a cordless Dyson (not sure which model but probably a V6) that is not working when plugged in the wand or any accessories that requires power. The other accessories which don’t have any rotation works fine.I have cleaned the filter and connection but it doesn’t work, can you help?

3 months ago

CommeenRookie Member

asked in Maintaining your Dyson cordless vacuum

How should I maintain my Dyson Cyclone V10 vacuum's brush bar?

Direct drive cleaner head over-susceptible to fouling/tangling from hair inside locking device(Moderation edit - title updated)

3 months ago

Dan ChevionNovice Member

asked in Maintaining your Dyson cordless vacuum

V15 particle count - Particle counter screen not switching on.

I found the following instructions to reset the particle count: "To reset the particle count, your machine needs to be charged for at least 30 minutes, or you can remove the Click-in battery for 15 seconds before clicking back in." Unfortunately, that didn't work for me. Resetting it directly with the one button selector doesn't work either. Would anyone be able to help me with this issue?

4 months ago

steveeeNew Member

asked in Maintaining your Dyson cordless vacuum

V7 Motorhead 3 prong brushbar - part number

Hi, I’m struggling to find a part number for the V7 Motorhead 3 prong brush bar. I called customer service and the part number 967157-01 they gave me is for a 4 prong brush bar. I called back and they admitted that they couldn’t say what the right part number is.What’s the part number for the V7 Motorhead 3 prong brush bar or where can I buy one?

4 months ago

jameshillhouseRookie Member

asked in Maintaining your Dyson cordless vacuum

V7 not charging

I have read all the trouble-shooting and actioned what they say re blockages etc but still no luck!V7 not runningNo blockages in filters or tubesWhen pull trigger blue light flashes 10 times then goes offPlugged into charger and on at mains, no lightsLeave for an hour, no lightsUnplug and pull trigger, blue light flashes 10 timesRepeat process but with no change.Anyone able to give me advice? Is it the mains connector cable? Battery does flash blue and no red light so assume it’s ok.

4 months ago

rgambergNew Member

asked in Maintaining your Dyson cordless vacuum

Dyson Repair in Mexico

My Dyson vacuum is not working and I need to get it repaired. Does anyone know how/where to get this repaired in Merida Yucatan Mexico?

4 months ago

Page 1 / 8

Didn't find the answer you were looking for?

Feel free to create a new topic and post your question on the community.

Create a topic

Terms & Conditions Cookie settings

Create a community account to start contributing.

New here? Register below. To activate you account and be able to post on the community, don't forget to click on the link in your activation email.

Username *

E-mail address *

A bit about yourself

Password *

I accept the terms & conditions

loginBox.register.email_repeat

Login to the community

No account yet? Create an account

Username or Email

Password

Remember me

Forgot password?

Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.

Enter your e-mail address

Back to overview

Scanning file for viruses.

Sorry, we're still checking this file's contents to make sure it's safe to download. Please try again in a few minutes.

This file cannot be downloaded

Sorry, our virus scanner detected that this file isn't safe to download.