Hi. I have a DC54 and I need to disassemble the Dual Mode Floor Tool (part no. 966247-01) to remove an unseen blockage. I have removed the 10 Torx screws, but it won't come apart. What else do I need to do, to open up this component?
Solved
How to disassemble Dual Mode Floor Tool Suction Control
Best answer by Jack
Hi
Welcome to the Dyson Community!
We wouldn’t recommend dismantling your Dual mode floor tool any further than is shown in the User guide or provide directions for doing so, as this could void your Dyson guarantee. It may also be tricky to reassemble afterwards.
If there’s a blockage within the airway through the tool, you should be able to remove this using a long, thin object to dislodge anything that’s trapped. It would be unusual for an item to be lodged so firmly it can’t be removed without dismantling the tool.
This inactive topic has now been automatically closed. For help or advice, please create a new topic.
+13Hi
Welcome to the Dyson Community!
We wouldn’t recommend dismantling your Dual mode floor tool any further than is shown in the User guide or provide directions for doing so, as this could void your Dyson guarantee. It may also be tricky to reassemble afterwards.
If there’s a blockage within the airway through the tool, you should be able to remove this using a long, thin object to dislodge anything that’s trapped. It would be unusual for an item to be lodged so firmly it can’t be removed without dismantling the tool.
Create a Community account to start contributing.
New here? Register below. To activate you account and be able to post on the community, don't forget to click on the link in your activation email.
Login to the community
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.