Hello. I just set up my new hot+cool purifier. The graphs both on the machine and on the application all show nil values except from the temperature which is displayed correctly. Is this normal? How long does it take after you first activate the machine and the app so that you start see the air quality graphs? I have activated the continuous monitoring.
Thanks
Best answer by lionel
To help re-establish this connection could you please follow the advice on the ‘'Power Cycling/Restarting' your machine’ article.
If you are still having a problem after this please post a reply.
Hey, the sensors take about an hour to initialise. You should be able to see readings after that.
Thanks Lionel. However this morning only the Nitrogen dioxide showed a figure. The rest are all at 0 including humidity. After so many hours I just feel there is something wrong or I did a mistake in the set up. Not sure what to think. It is disappointing.
To help re-establish this connection could you please follow the advice on the ‘'Power Cycling/Restarting' your machine’ article.
If you are still having a problem after this please post a reply.
Hey
After switching it off and back on again it seemed to resolve itself. Not quiet sure what cause it in the first place.
Thank you. It seems resetting was the answer after all. In some cases sensors need recalibration after transfer (as per Dyson engineer) so resetting is the solution.
New here? Register below. To activate you account and be able to post on the community, don't forget to click on the link in your activation email.
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
