Hello, I bought dyson airwrap yesterday, there is three lines on the buttons, is it a defect or is it normal?
Page 1 / 1
Hi
Welcome to the Dyson Community, and congratulations on your new Dyson Airwrap
multi-styler!
I can reassure you that these are just flowlines from the normal injection molding process. They’re not defects, and they’re nothing to be concerned about.
Hope this helps!
Create a Community account to start contributing.
New here? Register below. To activate you account and be able to post on the community, don't forget to click on the link in your activation email.
Login to the community
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.