+5Looking for some advice.
The robots filter has a narrow 2-3 inch opening, which allows the water to rise through the material and out the other side.
I’ve cleaned the filter for the first time and can still see dust/grime through this opening. Is there a Lyn easier way to clean inside, other than flushing it with water?
Thanks.
Charlie.
Best answer by Anonymous
Hey
There was me thinking it was only us that had this issue!
We found if we soak ours in warm water, for no more than an hour, it always seems to do the trick.
Follow this up by flushing it with cold water for about 5 minutes, squeezing the blue messy part until it runs clean.
In my book, doing a straight forward rinse doesn’t remove all that grime! This certainly helps!
Pete.
Hey
There was me thinking it was only us that had this issue!
We found if we soak ours in warm water, for no more than an hour, it always seems to do the trick.
Follow this up by flushing it with cold water for about 5 minutes, squeezing the blue messy part until it runs clean.
In my book, doing a straight forward rinse doesn’t remove all that grime! This certainly helps!
Pete.
There’s a post there from the CM
Best of luck 🤞
New here? Register below. To activate you account and be able to post on the community, don't forget to click on the link in your activation email.
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
