When the self clean is working, the first half of the cleaning process dispenses water from the clean canister to the dirty canister. During the second half of the cleaning process, no water is being used from the clean canister, just the roller brushes are spinning.
Is this normal?
Thanks
Best answer by aastha.27
Hi
Welcome to the Dyson community!
Thank you for getting in touch. This is normal for the Dyson Wash G1's self-clean cycle. During the first half of the cleaning process, water from the clean canister is dispensed into the dirty canister to help remove any residue. In the second half, the roller brushes spin without using additional water to ensure a thorough clean.
Here is the maintenance video:
Hope we’ve been able to clarify things, but you're always welcome back here at the Dyson Community if you need further support or advice at any point!
Hi
Welcome to the Dyson community!
Thank you for getting in touch. This is normal for the Dyson Wash G1's self-clean cycle. During the first half of the cleaning process, water from the clean canister is dispensed into the dirty canister to help remove any residue. In the second half, the roller brushes spin without using additional water to ensure a thorough clean.
Here is the maintenance video:
Hope we’ve been able to clarify things, but you're always welcome back here at the Dyson Community if you need further support or advice at any point!
New here? Register below. To activate you account and be able to post on the community, don't forget to click on the link in your activation email.
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
