Hi everyone,
I have a Dyson Purifier Humidify+Cool Formaldehyde PH04 which has grown a large amount of mold/algae in the water tank.
I would now like to deep clean the machine but, unfortunately, have been unable to determine how to manually initiate a deep clean cycle.
To reiterate, the machine does not show that a deep clean cycle is needed but I would like to manually start one.
Any assistance or advice would be greatly appreciated.
Thanks!
Best answer by Morcman
This is possible by pressing the deep clean cycle above the power button twice. Power on the machine, press the deep clean button and the machine shows how dirty the evaporator is. After that just press the deep clean button again and the deep clean process should start.
This is possible by pressing the deep clean cycle above the power button twice. Power on the machine, press the deep clean button and the machine shows how dirty the evaporator is. After that just press the deep clean button again and the deep clean process should start.
New here? Register below. To activate you account and be able to post on the community, don't forget to click on the link in your activation email.
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
