Love the Nav 360 but I have had to send it for repair when only a few weeks old due to the side actuator silicon being torn
just had it back for a couple of weeks and it is torn again
Looks like a possible design flaw
You cannot buy this part as a spare part at present and I do not want to return the machine again to Dyson for repair
Looks like a simple part to replace as there is a single screw holding the part on
Has Anyone else seen or had the same issue?
Best regards
Steve
Best answer by Morcman
Never seen this before. Seems like it gets stuck on something on your floor and ripped off. I would inspect your floor and or watch the robot move to see where this might happen.
Never seen this before. Seems like it gets stuck on something on your floor and ripped off. I would inspect your floor and or watch the robot move to see where this might happen.
New here? Register below. To activate you account and be able to post on the community, don't forget to click on the link in your activation email.
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
