Once the target temperature has been reached how far must the temperature fall before heater re-starts. that is, how sensitive is the thermostat. will heating restart after 1 degree fall or 0.1 degree fall.
When maintaining room temperature will a lower gentle heat be applied or the the full 2kw.
Best answer by Jack
Once the target temperature has been reached how far must the temperature fall before heater re-starts. that is, how sensitive is the thermostat. will heating restart after 1 degree fall or 0.1 degree fall.
When maintaining room temperature will a lower gentle heat be applied or the the full 2kw.
Hi
Dyson heaters let you set the target temperature to the degree. Once the target temperature has been reached, the machine will revert to monitoring mode - running at a very low speed to draw airflow past the temperature sensor. If it detects a drop in temperature, it will reactivate to maintain the target you’ve chosen.
Dyson heaters only have one output temperature, so it’s not a case of a lower heat being applied when the machine reactivates to restore the target temperature.
I hope this helps, but let us know if you have any further questions!
Purifier display only shows in whole units. I assume is there is a change from 32.0 to 31.9 degree, that the temperate unit would restart. There might not be an official answer, if you have a thermostat, might be worth testing it on your own machine.
My purifier heater jumps to the full heat to rewarm the room. I don’t know what kw this uses. sorry.
+13Once the target temperature has been reached how far must the temperature fall before heater re-starts. that is, how sensitive is the thermostat. will heating restart after 1 degree fall or 0.1 degree fall.
When maintaining room temperature will a lower gentle heat be applied or the the full 2kw.
Hi
Dyson heaters let you set the target temperature to the degree. Once the target temperature has been reached, the machine will revert to monitoring mode - running at a very low speed to draw airflow past the temperature sensor. If it detects a drop in temperature, it will reactivate to maintain the target you’ve chosen.
Dyson heaters only have one output temperature, so it’s not a case of a lower heat being applied when the machine reactivates to restore the target temperature.
I hope this helps, but let us know if you have any further questions!
New here? Register below. To activate you account and be able to post on the community, don't forget to click on the link in your activation email.
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
