Hello, just purchased and started using the V15 Detect. Superb, especially the soft roller with laser guidance. Have never seen anything like it! Wow! Anyhow, about the red trigger to activate the vacuum. I have read in other topics that after a few seconds of not using the trigger, the vacuum goes into standby mode. However, while emptying the bin, I wish I could stop it from running because I often wind up accidentally pressing the trigger. Thanks for any help.
Page 1 / 1
Hi
Welcome to the Dyson Community, and congratulations on your new Dyson V15 Detect
vacuum! I’m glad to hear it’s working so well for you.
To answer your question, there’s no way to disable the on/off trigger - the only time your machine won’t run when the trigger is pulled is when the battery is fully out of charge after use. When emptying your machine, take care to hold your machine by the non-trigger section of the hand grip to avoid accidentally activating the machine when the bin is open.
I’ve attached our Getting Started guide below in case it’s useful - although it sounds like you’re already up and running!
Hope this helps, but please come back to the Dyson Community if you need further support or advice at any point.
Thank you so much! The V15 Detect is indeed amazing. But I learned the hard way not to open the bin unless it is several inches inside our home garbage bin. The first time, I had to vacuum up the dust and dirt I spilled around it! 
Create a Community account to start contributing.
New here? Register below. To activate you account and be able to post on the community, don't forget to click on the link in your activation email.
Login to the community
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.